Comtech EF Data CDM-570A Installation And Operation Manual page 294

Command
Parameter (Instruction
Type Code and
Qualifier)
Retrieve next 5 N/A 75 bytes
unread Stored
Events
Clear All Stored CAE= None
Events
Initialize Events IEP= None
Pointer
Serial-based Remote Product Management
Arguments for
Command or
Response to
Query
Query only.
Returns the oldest 5 Stored Events which have not yet been read over the remote
interface.
Reply format: {CR}Sub-body{CR}Sub-body{CR}Sub-body{CR}Sub-body{CR}Sub-
body, where Sub-body= ABCddmmyyhhmmss,
A being the fault/clear indicator, where:
F = Fault
C = Clear
I = Info
B being the fault type, where:
1 = Unit
2 = Rx Traffic
3 = Tx Traffic
4 = ODU
5 = Power on/off, or log cleared
C is Fault Code numbers, as in FLT? or Info Code, where:
0 = Power Off
1 = Power On
2 = Log Cleared
3 = Global Config Change
4 = Redundancy Config Change
Notes:
1) If less than 5 events are to be retrieved, the remaining positions are padded with
zeros.
2) If there are no new events, the response is RNE*.
Command only.
This command takes no arguments.
Forces the software to clear the software events log.
Command only.
This command takes no arguments.
Resets internal pointer to allow RNE? queries to start at the beginning of the stored
events log.
CDM-570A/570AL Satellite Modem with Optional Packet Processor
Description of Arguments
8–28
Revision 5
Query
Response to
(Instruction Code
Command
and Qualifier)
N/A RNE? RNE={CR}ABCddm
myyhhmmss{CR}A
BCddmmyyhhmms
s{CR}ABCddmmyy
hhmmss{CR}ABCd
dmmyyhhmmss
{CR}ABCddmmyyh
hmmss (see
Description of
Arguments)
CAE= N/A N/A
CAE?
CAE*
CAE#
IEP= N/A N/A
IEP#
MN-CDM570A
Response to
Query