Comtech EF Data CDM-570A Installation And Operation Manual page 140

To edit the Tx Output Power Level, use the
▲▼arrow keys to change that digit. Press ENTER. Note the following:
•
For the CDM-570AL, the valid range of output power is from 0 dBm to –40 dBm.
•
For the CDM-570A, the valid range of output power is from 0 dBm to –25 dBm.
(CONFIG: Tx) Output Power Level Mode: AUPC
Appendix E. AUPC (AUTOMATIC UPLINK POWER CONTROL)
•
If you do not select 'Framed' or 'IP-ACM' mode, and you then attempt to select
AUPC, the modem displays the following message:
Warning! AUPC needs
Framed Mode or ACM Mode
This indicates Manual mode is active. Press ENTER or CLEAR to return to the previous
menu.
•
If you select IP, IP-ACM or V2-ACM, and then select (Config: Tx) Pwr AUPC, the
modem displays the AUPC submenu as follows:
Max-Range
DemodUnlock
◄ ►
Use the
(CONFIG: Tx) Output Power Level Mode: AUPC  Max-Range
Maximum-permitted Power
increase: 3.0dB(
Use the ▲▼ arrow keys to change the value of maximum permitted increase in power
level (when in AUPC mode). Press ENTER. The default value is 1 dB, and the upper
limit is 9 dB.
(CONFIG: Tx) Output Power Level Mode: AUPC  Tx-Alarm
Tx Alarm: None
MinModcod
To set the action that occurs if the AUPC causes the maximum output power level to be
reached, use the
ENTER.
(CONFIG: Tx) Output Power Level Mode: AUPC 
DemodUnlock
Action when Remote Demod
unlocks: Nom Max Hold ◄ ►
Front Panel Operation
CDM-570A/570AL Satellite Modem with Optional Packet Processor
Tx-Alarm
(◄ ►)
arrow keys to select a parameter. Press ENTER.
▲▼
,ENT)
MaxPower
◄ ►
arrow keys to select None, MaxPower, or MinModcod. Press
◄ ►
arrow keys to select a digit, and then use the
◄ ►
6–24
Revision 5
MN-CDM570A