Admin | Pap Features - Comtech EF Data CDM-570A Installation And Operation Manual

About Managed Switch Mode: Managed Switch Mode is Comtech's IP modem intelligent
networking solution. It is intended primarily for operation in a point-to-point topology. It allows a
link to be set up with minimal configuration (no specific routes need to be configured).
When the optional Packet Processor is not installed, Managed Switch Mode provides support for
Layer 2 QoS, and Dedicated Management Port or Virtual Local Area Network (VLAN).
When you install the optional Packet Processor, advanced features such as Layer 3/4/5
(Advanced) QoS, Header and Payload Compression are available. Most are accessible only
under "Admin" user access.
Sect. 7.4.3.3.5 Config | Managed Switch
7.4.3.2.4

Admin | PaP Features

1. This page is available only when you install the optional Packet Processor.
2. If you submit any changes to this page, you must also open the 'Admin |
Features – Standard
Use the drop-down lists to set operation as Enabled or Disabled:
• Telnet
• LAN-to-LAN Routing
• Downlink Route All Available Multicast
Click [Submit] to save.
Ethernet-based Remote Product Management
CDM-570A/570AL Satellite Modem with Optional Packet Processor
Pap Save' page (see Sect. 7.4.3.2.8) and immediately click [Save PaP
Parameters].
Figure 7-8. Admin | PaP Features Page
• Ping Reply
• L2 Tx Header Compression
• Managed Switch Multicast Option
• L2 Rx Header Compression
7–20
Revision 5
MN-CDM570A