Comtech EF Data CDM-570A Installation And Operation Manual page 48

LED Interfaces – Depending on the frequency, up to 14 LEDs are available:
•
For the CDM-570AL or CDMR-570AL – A red LED labeled "DC On! Caution!" is
provided for the "Rx" (at far left) and the "Tx" (at far right) Type 'N' connectors, each
indicating the presence of DC voltage.
•
Six LEDs, all orange, indicate the active data interface type: RS422/EIA530, RS232,
V.35, E1-B (G.703 E1 Balanced, E1-U (G.703 E1 Unbalanced), or T1 (G.703 T1).
•
A green LED labeled "ACT" and an orange LED labeled "M&C 100" indicate operational
status and the passing of 10/100 BaseT Ethernet-based remote product management
data.
•
For systems in an optional redundant configuration:
o
o
o
Utility and Traffic Data Interfaces:
•
(1X) "Data Interface" DB-25F connector for serial-based synchronous data input/output.
•
(1X) "Remote Control" DB-9M connector for EIA-232/-485 serial-based remote product
management.
•
(1X) "10/100 Ethernet | M&C 100" RJ-45 modular port for Ethernet-based remote product
management.
•
(1X each) "Unbal E1 | In" and "Unbal E1 | Out" BNC connectors for unbalanced G.703 E1
traffic.
•
(1X) "Balanced E1/T1" DB-15F connector for balanced G.703 E1/T1 traffic.
•
(1X) "Alarms" DB-15M connector for user access to the Form-C relay contacts that
indicate the modem alarms/fault status.
•
(1X) "Ext Ref In/Out" BNC female connector for External Reference.
Introduction
CDM-570A/570AL Satellite Modem with Optional Packet Processor
When the modem is connected to a 1:N switch, a red LED labeled "1:N
Caution!" indicates that there may be DC voltages and other control signals
present on certain pins on the 25-pin Data Interface connector.
A green LED labeled "Online" indicates the Online/Offline status of the modem.
A slide switch provides Off/On selection of the 1:N mode.
1–8
Revision 5
MN-CDM570A