Redundancy Configuration - Comtech EF Data CDM-570A Installation And Operation Manual

9.3.9

Redundancy Configuration

Appendix N. IP REDUNDANCY
Open the Redundancy Configuration page from the Main Menu.
Selection
1:1 Redundancy
1:1 Redundancy State
Traffic IP Address
Traffic Subnet Prefix
Length
Management IP Address
(Local Unit)
Management Subnet
Prefix Length (Local Unit)
Optional Packet Processor - Serial/Telnet CLI Operation
CDM-570A/570AL Satellite Modem with Optional Packet Processor
Figure 9-49. 1:1 Redundancy Configuration
Hot Key
R Toggle [Enabled] or [Disabled].
NOTE: Only enable Redundancy when connected with another
CDM-570A/570AL via a CRS-180 or CRS-170A redundancy switch.
[RO] • If standalone CDM-570A/570AL – displays state as Online.
• If Redundant CDM-570A/570AL – displays state as Online or Offline
[RO] • If standalone CDM-570A/570AL – not used.
• If Online Redundant CDM-570A/570AL – sets Traffic IP (read/write).
• If Offline Redundant CDM-570A/570AL – displays Traffic IP (read-
only).
[RW] • If standalone CDM-570A/570AL – not used.
[RO]
• If Online Redundant CDM-570A/570AL – sets Traffic Subnet
(read/write).
• If Offline Redundant CDM-570A/570AL – displays Traffic Subnet
(read-only).
[RO] • If standalone CDM-570A/570AL – not used.
• If Online Redundant CDM-570A/570AL – displays Local Management
IP
• If Offline Redundant CDM-570A/570AL – displays Local Management
IP
[RO]
• If standalone CDM-570A/570AL – not used.
• If Online Redundant CDM-570A/570AL – displays Local Management
Subnet
• If Offline Redundant CDM-570A/570AL – displays Local Management
Subnet
9–63
Description
MN-CDM570A
Revision 5