Cdm/R-570Al Buc And Lnb M&C Via Serial Remote Control Commands/Queries - Comtech EF Data CDM-570A Installation And Operation Manual

10.3.3 CDM/R-570AL BUC and LNB M&C via Serial Remote Control
Commands/Queries
Chapter 8. SERIAL-BASED REMOTE PRODUCT MANAGEMENT
The operands available through CDM/R-570AL Serial-based Remote Product Management are
identified in the following table – details on using these ODU-specific remote commands and
queries are explicitly defined in Chapter 8.
Operand Description
Query only – the unit returns the oldest 5 Stored Events which have not yet been read over the
RNE
remote control.
OGC Command or Query – ODU Global Configuration of CDM/R-570AL
Query only – Unit returns the current highest-priority fault and status codes for the unit (hardware),
FLT
Tx Traffic, Rx Traffic and ODU
ODU (Transceiver, BUC, LNB) Operation
CDM-570A/570AL Satellite Modem with Optional Packet Processor
10–48
Revision 5
MN-CDM570A