Ethernet Configuration Commands
78-20269-01 Command Line Interface Reference Guide
Example
The following example enables jumbo frames on the device.
Console(config)#
port jumbo-frame
21.12 clear counters
Use the show interfaces counters EXEC mode command to display traffic seen by
all the physical interfaces or by a specific interface.
Syntax
show interfaces counters
Parameters
interface-id—Specifies an interface ID. The interface ID can be one of the
following types: Ethernet port or Port-channel.
detailed—Displays information for non-present ports in addition to present ports.
Command Mode
EXEC mode
Example
The following example clears the statistics counters for gi5.
Console#
clear counters gi5.
21.13 set interface active
Use the set interface active EXEC mode command to reactivate an interface that
was shut down.
Syntax
{interface-id}
set interface active
[interface-id] [detailed]
21
282