Bridge Multicast Forbidden Address - Cisco Small Business 300 1.1 Series Administration Manual

Address Table Commands
78-20269-01 Command Line Interface Reference Guide
Console(config)# interface vlan
Console(config-if)#
27.4

bridge multicast forbidden address

Use the bridge multicast forbidden address Interface Configuration (VLAN) mode
command to forbid adding or removing a specific multicast address to or from
specific ports. Use the no form of this command to restore the default
configuration.
Syntax
bridge multicast forbidden address {
{ethernet interface-list | port-channel port-channel-list
no bridge multicast forbidden address {
Parameters
•
mac-multicast-address—Specifies the group MAC multicast address.
•
add—Forbids adding ports to the group.
•
remove—Forbids removing ports from the group.
•
interface-list
ethernet
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
•
port-channel-list
port-channel
nonconsecutive port-channels with a comma and no spaces. Use a hyphen
to designate a range of port channels.
Default Configuration
No forbidden addresses are defined.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
Before defining forbidden ports, the multicast group should be registered.
You can execute the command before the VLAN is created.
8
bridge multicast address
mac-multicast-address
mac-multicast-address
—Specifies a list of Ethernet ports. Separate
—Specifies a list of port channels. Separate
01:00:5e:02:02:03
add
{add | remove}
}
}
}
27
gi1-2
327