Show Ipv6 Mld Snooping Groups - Cisco Small Business 300 1.1 Series Administration Manual

IPv6 MLD Snooping Commands
78-20269-01 Command Line Interface Reference Guide
Groups that are in MLD version 1 compatibility mode:
FF12::3, FF12::8
MLD snooping robustness:admin 2
MLD snooping query interval: admin 125 sec
MLD snooping query maximum response: admin 10 sec
MLD snooping last member query counter: admin 2
MLD snooping last member query interval: admin 1000 msec
MLD snooping last immediate leave: enable
Automatic learning of multicast router ports is enabled

32.15 show ipv6 mld snooping groups

The show ipv6 mld snooping groups EXEC mode command displays the multicast
groups learned by the MLD snooping.
Syntax
show ipv6 mld snooping groups
[source ipv6-address]
Parameters
•
vlan vlan-id—Specifies the VLAN ID.
•
address ipv6-multicast-address—Specifies the IPv6 multicast address.
•
source ipv6-address—Specifies the IPv6 source address.
Command Mode
EXEC mode
User Guidelines
To see the full multicast address table (including static addresses), use the show
bridge multicast address-table command.
The Include list contains the ports which are in a forwarding state for this group
according to the snooping database. In general, the Exclude list contains the ports
which have issued an explicit Exclude for that specific source in a multicast group.
oper 2
oper 125 sec
oper 10 sec
oper 2
[vlan vlan-id [address ipv6-multicast-address]
]
32
oper 600 msec
462