Ethernet Configuration Commands
78-20269-01 Command Line Interface Reference Guide
Console(config-if)#
21.9
mdix
Use the mdix Interface Configuration (Ethernet) mode command to enable cable
crossover on a given interface. Use the no form of this command to disable cable
crossover.
Syntax
{on | auto}
mdix
no mdix
Parameters
•
on—Enables manual MDIX.
•
auto—Enables automatic MDI/MDIX.
Default Configuration
The default setting is On.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example enables automatic crossover on port
Console(config)#
interface gi5
Console(config-if)# mdix auto
21.10 back-pressure
Use the back-pressure Interface Configuration (Ethernet) mode command to
enable back pressure on a specific interface. Use the no form of this command to
disable back pressure.
flowcontrol on
21
5.
gi
280