Sntp Authenticate - Cisco Small Business 300 1.1 Series Administration Manual

Clock Commands
78-20269-01 Command Line Interface Reference Guide
•
key-value
md5
Default Configuration
No authentication key is defined.
Command Mode
Global Configuration mode
Examples
The following example defines the authentication key for SNTP.
Console(config)#
sntp authentication-key
Device(config)# sntp authentication-key 8 md5 ClkKey
Device(config)# sntp trusted-key 8
Device(config)# sntp authenticate
6.7

sntp authenticate

The sntp authenticate Global Configuration mode command enables
authentication for received Simple Network Time Protocol (SNTP) traffic from
servers. Use the no form of this command to disable the feature.
Syntax
sntp authenticate
no sntp authenticate
Parameters
N/A
Default Configuration
Authentication is disabled.
Command Mode
Global Configuration mode
—Specifies the key value. (Length: 1–8 characters)
8 ClkKey
md5
6
104