Dot1X Timeout Server-Timeout - Cisco Small Business 300 1.1 Series Administration Manual

802. 1 x Commands
78-20269-01 Command Line Interface Reference Guide
User Guidelines
The default value of this command should be changed only to adjust to unusual
circumstances, such as unreliable links or specific behavioral problems with
certain clients and authentication servers.
Example
The following example sets the time interval during which the device waits for a
response to an EAP request frame from the client before resending the request to
3600 seconds.
Console(config)#
interface gi15
Console(config-if)#

20.10 dot1x timeout server-timeout

Use the dot1x timeout server-timeout Interface Configuration (Ethernet) mode
command to set the time interval during which the device waits for a response
from the authentication server. Use the no form of this command to restore the
default configuration.
Syntax
dot1x timeout server-timeout
no dot1x timeout server-timeout
Parameters
server-timeout seconds
device waits for a response from the authentication server. (Range: 1–65535
seconds)
Default Configuration
The default timeout period is 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
dot1x timeout supp-timeout
seconds
—Specifies the time interval in seconds during which the
3600
20
257