Show Bridge Multicast Reserved-Addresses - Cisco Small Business 300 1.1 Series Administration Manual

Address Table Commands
78-20269-01 Command Line Interface Reference Guide
Default Configuration
If an <address, frame type, protocol> tuple is mapped to an application that is
supported by the device then the default is Peer (handled by the application
rules). Otherwise:
For addresses in the range 01-80-C2-00-00-00, 01-80-C2-00-00-02–
01-80-C2-00-00-0F, the default is discard. For addresses in the range
00-80-C2-00-00-10– 01-80-C2-00-00-2F, the default is bridge.
Command Mode
Global Configuration mode
User Guidelines
If the packet/service type is not specified, the configuration is relevant to all the
packets with the configured MAC address.
Specific configurations (that contain service type) have precedence over less
specific configurations (contain only MAC address).
The packets that are bridged are subject to security ACLs.
The actions define by this command has precedence over forwarding rules
defined by applications/protocols (STP, LLDP etc.) supported on the device.

27.31 show bridge multicast reserved-addresses

Use the show bridge multicast reserved-addresses EXEC mode command to
display the multicast reserved-address rules.
Syntax
show bridge multicast reserved-addresses
Command Mode
EXEC mode
Example
Console # show bridge multicast reserved-addresses
MAC addressFrame typeProtocolAction
------------------------------------------------------
27
358