Lldp Reinit; Lldp Tx-Delay - Cisco Small Business 300 1.1 Series Administration Manual

Link Layer Discovery Protocol (LLDP) Commands
78-20269-01 Command Line Interface Reference Guide
44.6

lldp reinit

Use the lldp reinit Global Configuration mode command to specify the minimum
time an LLDP port waits before reinitializing LLDP transmission. Use the no form of
this command to revert to the default setting.
Syntax
seconds
lldp reinit
no lldp reinit
Parameters
seconds
reinit —Specifies the minimum time in seconds an LLDP port waits before
reinitializing LLDP transmission.(Range: 1–10)
Default Configuration
2 seconds
Command Mode
Global Configuration mode
Example
console(config)# lldp reinit 4
44.7

lldp tx-delay

Use the lldp tx-delay Global Configuration mode command to set the delay
between successive LLDP frame transmissions initiated by value/status changes
in the LLDP local systems MIB. Use the no form of this command to restore the
default configuration.
Syntax
seconds
lldp tx-delay
no lldp tx-delay
44
652