Address Table Commands
78-20269-01 Command Line Interface Reference Guide
Example
The following example forbids MAC address 0100.5e02.0203 on port
VLAN 8.
Console(config)#
interface vlan
Console(config-if)#
Console(config-if)#
27.5
bridge multicast ip-address
Use the bridge multicast ip-address Interface Configuration (VLAN) mode
command to register IP-layer multicast addresses to the bridge table, and
statically add or remove ports to or from the group. Use the no form of this
command to unregister the IP address.
Syntax
bridge multicast ip-address
interface-list
port-channel port-channel-list
|
no bridge multicast ip-address
Parameters
•
ip-multicast-address—Specifies the group IP multicast address.
•
add—Adds ports to the group.
•
remove—Removes ports from the group.
•
interface-list
ethernet
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
•
port-channel-list
port-channel
nonconsecutive port-channels with a comma and no spaces. Use a hyphen
to designate a range of port channels.
Default Configuration
No Multicast addresses are defined.
Default option is add.
8
bridge multicast address
bridge multicast forbidden address
ip-multicast-address [[add | remove] {ethernet
ip-multicast-address
—Specifies a list of Ethernet ports. Separate
—Specifies a list of port channels. Separate
0100.5e02.0203
0100.5e02.0203
}]
27
within
gi9
gi9
add
328