Quality of Service (QoS) Commands
78-20269-01 Command Line Interface Reference Guide
Parameters
•
gigabitethernet—Specifies that the thresholds are to be applied to Gigabit
Ethernet ports.
•
queue-id—Specifies the queue number to which the tail-drop threshold is
assigned.
•
threshold-percentage—Specifies the queue threshold percentage value.
Default Configuration
The default threshold is 80 percent.
Command Mode
Global Configuration mode
User Guidelines
If the threshold is exceeded, packets with the corresponding Drop Precedence
(DP) are dropped until the threshold is no longer exceeded.
Example
The following example assigns a threshold of 80 percent to WRR queue 1.
Console(config)#
qos wrr-queue threshold gigabitethernet
41.29 qos map policed-dscp
Use the qos map policed-dscp Global Configuration mode command to configure
the policed-DSCP map for remarking purposes. Use the no form of this command
to restore the default configuration.
This command is only available in QoS advanced mode.
Syntax
qos map policed-dscp
no qos map policed-dscp [
dscp-list to dscp-mark-down
dscp-list
]
41
1 80
587