Cisco Small Business 300 1.1 Series Administration Manual page 288

Ethernet Configuration Commands
78-20269-01 Command Line Interface Reference Guide
The following table describes the fields shown in the display.
Field
InOctets
InUcastPkts
InMcastPkts
InBcastPkts
OutOctets
OutUcastPkts
OutMcastPkts
OutBcastPkts
FCS Errors
Single Collision Frames
Multiple Collision
Frames
SQE Test Errors
Deferred Transmissions
Late Collisions
Excessive Collisions
Description
The number of received octets.
The number of received unicast packets.
The number of received multicast
packets.
The number of received broadcast
packets.
The number of transmitted octets.
The number of transmitted unicast
packets.
The number of transmitted multicast
packets.
The number of transmitted broadcast
packets.
The number of frames received that are
an integral number of octets in length but
do not pass the FCS check.
The number of frames that are involved in
a single collision, and are subsequently
transmitted successfully.
The number of frames that are involved in
more than one collision and are
subsequently transmitted successfully.
The number of times that the SQE TEST
ERROR is received. The SQE TEST
ERROR is set in accordance with the
rules for verification of the SQE detection
mechanism in the PLS Carrier Sense
Function as described in IEEE Std. 802.3,
2000 Edition, section 7.2.4.6.
The number of frames for which the first
transmission attempt is delayed because
the medium is busy.
The number of times that a collision is
detected later than one slotTime into the
transmission of a packet.
The number of frames for which
transmission fails due to excessive
collisions.
21
289