Show Macro Auto Ports - Cisco Small Business 300 1.1 Series Administration Manual

Smartport Commands
78-20269-01 Command Line Interface Reference Guide
Default Configuration
N/A
Command Mode
EXEC
Example
switch>show macro auto smartport
Smartport type: ip_phone
Parameters: $native_vlan=1 $voice_vlan=100
Smartport Macro: phone (built-in)
Smartport type: switch
Parameters: $native_vlan =1 $man=aa $enc=qq
Smartport Macro: use-switch
Smartport type: router
Parameters: $native_vlan =2
Smartport Macro: router (built-in)

43.14 show macro auto ports

The show macro auto ports EXEC mode command displays information about all
Smartport ports or a specific one. If a macro was run on the port and it failed, the
type of the port is displayed as Unknown.
Syntax
show macro auto ports [
Parameters
interface-id—Interface Identifier (Ethernet interface, port channel)
Default Configuration
Information about all ports is displayed.
Command Mode
EXEC
interface-id
]
43
643