Show Power Inline - Cisco Small Business 300 1.1 Series Administration Manual

Power over Ethernet (PoE) Commands
78-20269-01 Command Line Interface Reference Guide
Command Mode
Global Configuration mode
Example
The following example sets the power limit to class.
console(config)# power inline limit-mode class
23.7

show power inline

Use the show power inline EXEC mode command to display information about the
inline power for all interfaces or for a specific interface.
Syntax
interface-id
show power inline [
Parameters
interface-id—Specifies an interface ID. The interface ID must be an Ethernet port.
Default Configuration
There is no default configuration for this command.
Command Mode
EXEC mode
Example
The following example displays information about the inline power for all ports
(port power based).
console(config)# show power inline
Port based power-limit mode
Unit Power Nominal
Power
---- ------- -------
1 Off 1 Watts
]
Consumed Usage
Power Threshold
----------- ------
0 Watts (0%) 95
Traps
--------
Disable
23
302