Show Ip Dhcp Relay - Cisco Small Business 300 1.1 Series Administration Manual

DHCP Relay Commands
78-20269-01 Command Line Interface Reference Guide
Parameters
ip-address—Specifies the DHCP server IP address. Up to 8 servers can be
defined.
Default Configuration
No server is defined.
Command Mode
Global Configuration mode
Example
The following example defines the DHCP server on the device.
Console(config)#
ip dhcp relay address
38.4

show ip dhcp relay

Use the show ip dhcp relay EXEC mode command to display the DHCP relay
information.
Syntax
show ip dhcp relay
Command Mode
EXEC mode
Examples
Example 1 - Option 82 is not supported:
console# show ip dhcp relay
DHCP relay is globally enabled
Option 82 is Disabled
Maximum number of supported VLANs without IP Address is 256
Number of DHCP Relays enabled on VLANs without IP Address is 0
DHCP relay is not configured on any port.
176.16.1.1
38
526