Link Layer Discovery Protocol (LLDP) Commands
78-20269-01 Command Line Interface Reference Guide
Default Configuration
Disabled.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example enables sending LLDP notifications on gi5.
Console(config)#
interface gi5
Console(config-if)#
44.11 lldp notifications interval
Use the lldp notifications interval Global Configuration mode command to
configure the maximum transmission rate of LLDP notifications. Use the no form of
this command to return to the default.
Syntax
lldp notifications interval
no lldp notifications interval
Parameters
interval
seconds
—The device does not send more than a single notification in the
indicated period (range: 5–3600).
Default Configuration
5 seconds
Command Mode
Global Configuration mode
Example
console(config)# lldp notifications interval 10
enable
lldp notifications
seconds
44
656