Table of Contents
Advertisement
Network Management Protocol (SNMP) Commands
78-20269-01 Command Line Interface Reference Guide
10.11 snmp-server contact
Use the snmp-server contact Global Configuration mode command to configure
the system contact (sysContact) string. Use the no form of the command to
remove the system contact information.
Syntax
snmp-server contact
no snmp-server contact
Parameters
text—Specifies the string describing system contact information. (Length: 1–160
characters)
Command Mode
Global Configuration mode
Example
The following example configures the system contact point called
Technical_Support.
Console(config)#
snmp-server contact
10.12 snmp-server location
Use the snmp-server location Global Configuration mode command to configure
the system location string. Use the no form of this command to remove the location
string.
Syntax
snmp-server location
no snmp-server location
Parameters
text—Specifies a string describing system location information. (Length: 1–160
characters)
text
Technical_Support
text
10
159
Advertisement
Table of Contents
