Cisco Small Business 300 1.1 Series Administration Manual page 700

CDP Commands
78-20269-01 Command Line Interface Reference Guide
Interface TLV: gi2
CDP is disabled on
gi
Example 3 - In this example, CDP is globally enabled and enabled on the port, but
the port is down and no information is displayed.
switch#show cdp tlv interface gi2
cdp globally is enabled
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
Interface TLV: gi3
CDP is enabled on 3
gi
Ethernet 3 is down
gi
Example 4 - In this example, CDP is globally enabled and enabled on the port,
which is up and information is displayed.
switch#show cdp tlv interface gi1
cdp globally is enabled
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
Interface TLV: gi1
CDP is enabled
Ethernet 1 is up,
gi
Device ID TLV: type is MAC address; Value is 00:11:22:22:33:33:44:44
Address TLV: IPv4: 1.2.2.2 IPv6:
Port_ID TLV: gi1
Capabilities: S, I
2
S - Switch, H - Host, I - IGMP, r - Repeater,
P - VoIP Phone,M - Remotely-Managed Device,
C - CAST Phone Port, W - Two-Port MAC Relay
S - Switch, H - Host, I - IGMP, r - Repeater,
P - VoIP Phone,M - Remotely-Managed Device,
C - CAST Phone Port, W - Two-Port MAC Relay
45
702