Table of Contents
Advertisement
Network Management Protocol (SNMP) Commands
78-20269-01 Command Line Interface Reference Guide
Command Mode
Global Configuration mode
Example
The following example defines the device location as New_York.
Console(config)#
snmp-server location
10.13 snmp-server set
Use the snmp-server set Global Configuration mode command to define the
SNMP MIB value.
Syntax
variable-name name value
snmp-server set
Parameters
•
variable-name—Specifies the SNMP MIB variable name, which must be a
valid string.
•
name value—Specifies a list of name and value pairs. Each name and value
must be a valid string. In the case of scalar MIBs, there is only a single
name-value pair. In the case of an entry in a table, there is at least one
name-value pair, followed by one or more fields.
Command Mode
Global Configuration mode
User Guidelines
Although the CLI can set any required configuration, there might be a situation
where an SNMP user sets a MIB variable that does not have an equivalent
command. To generate configuration files that support those situations, use the
snmp-server set command.
New_York
name2 value2
[
...]
10
160
Advertisement
Table of Contents
