Snmp-Server Engineid Remote - Cisco Small Business 300 1.1 Series Administration Manual

Network Management Protocol (SNMP) Commands
78-20269-01 Command Line Interface Reference Guide
vlan<integer> | ch<integer> | isatap<integer> |
interface-name =
<physical-port-name> | 0
decimal-number> | <integer><decimal-number
integer = <
decimal-number = 0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9
physical-port-name = Designated port number, for example gi1/1/16
The following combinations are possible:
•
ipv6_address%interface_id - Refers to the IPv6 address on the interface
specified.
•
ipv6_address%0 - Refers to the IPv6 address on the single interface on
which an IPv6 address is defined.
•
ipv6_address - Refers to the IPv6 address on the single interface on which
an IPv6 address is defined.
If the egress interface is not specified, the default interface is selected. Specifying
interface zone=0 is equal to not defining an egress interface.
Example
The following defines a host at the IP address displayed.
console(config)# snmp-server host 1.1.1.121 abc
10.8

snmp-server engineID remote

To specify the Simple Network Management Protocol (SNMP) engine ID of a
remote SNMP device, use the snmp-server engineID remote Global Configuration
mode command. Use the no form of this command to remove the configured
engine ID.
Syntax
snmp-server engineID remote
no snmp-server engineID remote
Parameters
•
ipv4-ip-address | ipv6 address—Pv4 or IPv6 address of the remote device
{ipv4-ip-address | ipv6 address} engineid-string
{ipv4-ip-address | ipv6 address}
10
>
156