Ipv6 Addressing Commands; Ipv6 Enable - Cisco Small Business 300 1.1 Series Administration Manual

IPv6 Addressing Commands

36
IPv6 Addressing Commands
78-20269-01 Command Line Interface Reference Guide
36.1

ipv6 enable

Use the ipv6 enable Interface Configuration (Ethernet, VLAN, Port-channel) mode
command to enable the IPv6 addressing mode on an interface. Use the no form of
this command to disable the IPv6 addressing mode on an interface.
Syntax
[no-autoconfig]
ipv6 enable
no ipv6 enable
Parameters
no-autoconfig—EnableS processing of IPv6 on an interface without stateless
address autoconfiguration procedure
Default Configuration
IPv6 addressing is disabled.
Unless you are using the no-autoconfig parameter, when the interface is enabled
stateless address autoconfiguration procedure is enabled.
Command Mode
Interface Configuration (Ethernet, VLAN, Port-channel) mode. It cannot be
configured for a range of interfaces (range context).
User Guidelines
The ipv6 enable command automatically configures an IPv6 link-local unicast
address on the interface, while also enabling the interface for IPv6 processing.
The no ipv6 enable command removes the entire IPv6 interface configuration.
To enable stateless address autoconfiguration on an enabled IPv6 interface, use
the IPv6 address autoconfig command.
Example
The following example enables VLAN 1 for the IPv6 addressing mode.
Console(config)# interface vlan 1
36
499