Rate-Limit (Vlan) - Cisco Small Business 300 1.1 Series Administration Manual

Quality of Service (QoS) Commands
78-20269-01 Command Line Interface Reference Guide
Parameters
•
committed-rate-kbps—Specifies the maximum number of kilobits per
second of ingress traffic on a port. The range is 100 – max port speed.
•
burst committed-burst-bytes
unspecified, defaults to 128K.
Default Configuration
Rate limiting is disabled.
Committed-burst-bytes is 128K.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Storm control and rate-limit (of Unicast packets) cannot be enabled simultaneously
on the same port.
Example
The following example limits the incoming traffic rate on gi5 to 150,000 kbps.
Console(config)# interface
Console(config-if)#

41.23 rate-limit (VLAN)

Use the Layer 2 rate-limit (VLAN) Global Configuration mode command to limit the
incoming traffic rate for a VLAN. Use the no form of this command to disable the
rate limit.
Syntax
rate-limit vlan-id committed-rate committed-burst
no rate-limit vlan
Parameters
•
vlan-id—Specifies the VLAN ID.
—The burst size in bytes (3000–19173960). If
gi 5
150000
rate-limit
41
580