Tunnel Commands
37
Tunnel Commands
78-20269-01 Command Line Interface Reference Guide
37.1
interface tunnel
Use the interface tunnel Global Configuration mode command to enter the
Interface Configuration (Tunnel) mode.
Syntax
interface tunnel
number
Parameters
number—Specifies the tunnel index.
Command Mode
Global Configuration mode
Example
The following example enters the Interface Configuration (Tunnel) mode.
Console(config)#
interface tunnel
Console(config-tunnel)#
37.2
tunnel mode ipv6ip
Use the tunnel mode ipv6ip Interface Configuration (Tunnel) mode command to
configure an IPv6 transition-mechanism global support mode. Use the no form of
this command to remove an IPv6 transition mechanism.
Syntax
{isatap}
tunnel mode ipv6ip
no tunnel mode ipv6ip
Parameters
isatap—Enables an automatic IPv6 over IPv4 Intra-Site Automatic Tunnel
Addressing Protocol (ISATAP) tunnel.
1
37
516