Port Channel Commands - Cisco Small Business 300 1.1 Series Administration Manual

Port Channel Commands

26
Port Channel Commands
78-20269-01 Command Line Interface Reference Guide
Use the channel-group Interface Configuration (Ethernet) mode command to
associate a port with a port-channel. Use the no form of this command to remove a
port from a port-channel.
Syntax
port-channel mode {on | auto}
channel-group
no channel-group
Parameters
•
port-channel—Specifies the port channel number for the current port to
join.
•
mode {on | auto}—Specifies the mode of joining the port channel. The
possible values are:
-
on—Forces the port to join a channel without an LACP operation.
-
auto—Forces the port to join a channel as a result of an LACP operation.
Default Configuration
The port is not assigned to a port-channel.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example forces port
operation.
Console(config)#
interface gi1
Console(config-if)#
1 to join port-channel 1 without an LACP
gi
channel-group 1 mode on
26
319