Cisco Small Business 300 1.1 Series Administration Manual page 77

System Management Commands
78-20269-01 Command Line Interface Reference Guide
•
keyword—Specifies the one or more keywords listed in the Keywords
table in the User Guidelines.
Default Configuration
The default port is the Telnet port (23) on the host.
By default, Telnet is disabled.
Command Mode
EXEC mode
User Guidelines
Telnet software supports special Telnet commands in the form of Telnet
sequences that map generic terminal control functions to operating
system-specific functions. To enter a Telnet sequence, press the escape
sequence keys (Ctrl-shift-6) followed by a Telnet command character.
Special Telnet Sequences
Telnet Sequence Purpose
Ctrl-shift-6-b Break
Ctrl-shift-6-c Interrupt Process (IP)
Ctrl-shift-6-h Erase Character (EC)
Ctrl-shift-6-o Abort Output (AO)
Ctrl-shift-6-t Are You There? (AYT)
Ctrl-shift-6-u Erase Line (EL)
At any time during an active Telnet session, available Telnet commands can be
listed by pressing the
A sample of this list follows.
Console> ?
/help
[Special telnet escape help]
^^ B sends telnet BREAK
^^ C sends telnet IP
keys at the system prompt.
?/help
5
78