Ipv6 Mld Query-Interval - Cisco Small Business 300 1.1 Series Administration Manual

IPv6 MLD Snooping Commands
78-20269-01 Command Line Interface Reference Guide
group. Use the no form of this command to remove ports specified as members of
a static multicast group.
Syntax
vlan vlan-id
ipv6 mld snooping
no ipv6 mld snooping
Parameters
•
vlan-id—Specifies the VLAN.
•
ipv6-address—Specifies the IP multicast address
•
interface-list—Specifies list of interfaces. The interfaces can be from one of
the following types: Ethernet port or Port-channel.
Default Configuration
No multicast addresses are defined.
Command Mode
Global configuration mode
User Guidelines
Static multicast addresses can only be defined on static VLANs.
You can execute the command before the VLAN is created.
You can register an entry without specifying an interface.
Using the no command without a port-list removes the entry.
Example
console(config)# ipv6 mld snooping vlan 1 static 239.2.2.2
32.8

ipv6 mld query-interval

Use the ipv6 mld query-interval Interface Configuration mode command to
configure the Query interval. Use the no format of the command to return to
default.
ipv6-address interface [interface-list]
static
vlan vlan-id ipv6-address interface [interface-list]
static
32
gi1
456