Snmp-Server Group - Cisco Small Business 300 1.1 Series Administration Manual

Network Management Protocol (SNMP) Commands
78-20269-01 Command Line Interface Reference Guide
Command Mode
Global Configuration mode
User Guidelines
This command can be entered multiple times for the same view record.
The command logical key is the pair (view-name, oid-tree).
The number of views is limited to 64.
Default and DefaultSuper views are reserved for internal software use and cannot
be deleted or modified.
Example
The following example creates a view that includes all objects in the MIB-II system
group except for sysServices (System 7) and all objects for interface 1 in the
MIB-II interface group.
Console(config)# snmp-server view
Console(config)#
snmp-server view
Console(config)# snmp-server view
10.4

snmp-server group

The snmp-server group Global Configuration mode command configures a new
Simple Network Management Protocol (SNMP) group or a table that maps SNMP
users to SNMP views. Use the no form of this command, remove a specified SNMP
group.
Syntax
snmp-server group groupname
[read readview] [write writeview]
no snmp-server group
Parameters
•
groupname—Specifies the group name. (Length: 1–30 characters)
•
v1—Specifies the SNMP Version 1 security model.
•
v2—Specifies the SNMP Version 2 security model.
user-view system
user-view system.7
user-view ifEntry.*.1
{ v1 | v2 | v3 {noauth | auth | priv} [notify notifyview]}
groupname {v1 | v2 | v3 [noauth | auth | priv]} [context name]
10
included
excluded
included
149