Tunnel Isatap Query-Interval - Cisco Small Business 300 1.1 Series Administration Manual

Tunnel Commands
78-20269-01 Command Line Interface Reference Guide
interface is not changed when the IPv4 address is moved to another
interface.
Default
No source address is defined.
Command Mode
Interface Configuration (Tunnel) mode
User Guidelines
The configured source IPv4 address is used for forming the tunnel interface
identifier. The interface identifier is set to the 8 least significant bytes of the SIP
field of the encapsulated IPv6 tunneled packets.
Example
console(config)# interface tunnel 1
console(config-tunnel)# tunnel source auto
37.5

tunnel isatap query-interval

Use the tunnel isatap query-interval Global Configuration mode command to set
the time interval between Domain Name System (DNS) queries (before the ISATAP
router IP address is known) for the automatic tunnel router domain name. Use the
no form of this command to restore the default configuration.
Syntax
tunnel isatap query-interval
no tunnel isatap query-interval
Parameters
seconds—Specifies the time interval in seconds between DNS queries. (Range:
10–3600)
Default Configuration
The default time interval between DNS queries is 10 seconds.
seconds
37
519