Show Macro Auto Processing - Cisco Small Business 300 1.1 Series Administration Manual

Smartport Commands
78-20269-01 Command Line Interface Reference Guide
Parameters
smartport-type—Smartport type (range: printer, desktop, guest, server, host,
ip_camera, ip_phone, ip_phone_desktop, switch, router or wireless access point
(ap)).
parameter-name value—Specifies the parameter name and its value. These are
the parameters of the built-in or user-defined macro defined in
smartport macro.
Default Configuration
The default value of parameter $native_vlan of the built-in Smartport macros is 1.
For other parameters, the default value is the parameter's default value. For
instance, if the parameter is the native VLAN, the default value is the default native
VLAN.
Command Mode
Global Configuration
User Guidelines
By default, each Smartport type is associated with a pair of built-in macros: a
macro that applies the configuration and the anti macro (no macro) to remove the
configuration. The Smartport types are the same as the name of the
corresponding built-in Smartport macros, with the anti macro prefixed with no_.
The value of the parameter $voice_vlan cannot be changed by this command.
Example
To change the parameters of a built-in macro:
console(conf)#macro auto built-in parameters switch &native_vlan 2

43.12 show macro auto processing

The show macro auto processing EXEC mode command displays information
about which protocols (CDP/LLDP) are enabled and which device types can be
detected automatically.
Syntax
show macro auto processing
43
macro auto user
641