Bridge Multicast Ipv6 Ip-Address - Cisco Small Business 300 1.1 Series Administration Manual

Address Table Commands
78-20269-01 Command Line Interface Reference Guide

27.10 bridge multicast ipv6 ip-address

Use the bridge multicast ipv6 ip-address Interface Configuration (VLAN) mode
command to register an IPv6 multicast address to the bridge table, and statically
add or remove ports to or from the group. Use the no form of this command to
unregister the IPv6 address.
Syntax
bridge multicast ipv6 ip-address
interface-list |
port-channel port-channel-list}]
no bridge multicast ipv6 ip-address
Parameters
•
ipv6-multicast-address—Specifies the group IPv6 multicast address.
•
add—Adds ports to the group.
•
remove—Removes ports from the group.
•
interface-list
ethernet
nonconsecutive Ethernet ports with a comma and no spaces; use a hyphen
to designate a range of ports.
•
port-channel-list
port-channel
nonconsecutive port-channels with a comma and no spaces. Use a hyphen
to designate a range of port channels.
Default Configuration
No multicast addresses are defined.
The default option is add.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
To register the group in the bridge database without adding or removing ports or
port channels, specify the ipv6-multicast-address parameter only.
Static Multicast addresses can be defined on static VLANs only.
ipv6-multicast-address [[add | remove] {ethernet
ip-multicast-address
—Specifies a list of Ethernet ports. Separate
—Specifies a list of port channels. Separate
27
335