Address Table Commands
78-20269-01 Command Line Interface Reference Guide
Example
The following example displays dynamic addresses in all currently locked ports.
Console#
show ports security addresses
Port
Status
----
--------
gi1
Enabled
gi2
Disabled
gi3
Enabled
27.30 bridge multicast reserved-address
Use the bridge multicast reserved-address Global Configuration mode command
to define the action on multicast reserved-address packets. Use the no form of this
command to revert to default.
Syntax
bridge multicast reserved-address
llc sap | llc-snap pid] {discard | bridge}
no bridge multicast reserved-address
ethtype | llc sap | llc-snap pid]
Parameters
•
mac-multicast-address—MAC multicast address in the reserved MAC
addresses range.(Range: 01-80-C2-00-00-00,
01-80-C2-00-00-02–01-80-C2-00-00-2F)
•
ethernet-v2 ethtype—Specifies that the packet type is Ethernet v2 and the
Ethernet type field (16 bits in hexadecimal format).(Range: 0x0600–0xFFFF)
•
llc sap—Specifies that the packet type is LLC and the DSAP-SSAP field (16
bits in hexadecimal format).(Range: 0xFFFF)
•
llc-snap pid—Specifies that the packet type is LLC-SNAP and the PID field
(40 bits in hexadecimal format). (Range: 0x0000000000 - 0xFFFFFFFFFF)
•
discard—Specifies discarding the packets.
•
bridge—Specifies bridging the packets
Learning
Current
-------------
-------
Max-addresses
2
Max-addresses
-
Lock
NA
mac-multicast-address [ethernet-v2 ethtype |
mac-multicast-address [ethernet-v2
27
Maximum
-------
3
128
NA
357