Switchport Access Vlan - Cisco Small Business 300 1.1 Series Administration Manual

Virtual Local Area Network (VLAN) Commands
78-20269-01 Command Line Interface Reference Guide
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
•
When the port's mode is changed, it receives the configuration
corresponding to the mode.
•
If the port mode is changed to access and the access VLAN does not exist,
then the port does not belong to any VLAN.
•
Trunk and general mode ports can be changed to access mode only if all
VLANs (except for an untagged PVID are first removed.
Example
The following example configures gi1 as an access port (untagged layer 2) VLAN
port.
Console(config)# interface gi1
Console(config-if)#
Console(config-if)#

30.12 switchport access vlan

An interface in access mode can belong to only one VLAN. The switchport access
vlan Interface Configuration command reassigns an interface to a different VLAN
than it currently belongs to.
Use the no form of this command to restore the default configuration.
Syntax
switchport access vlan
no switchport access vlan
Parameters
vlan-id
vlan —Specifies the VLAN ID to which the port is configured.
Default Configuration
The interface belongs to the default VLAN.
switchport mode access
switchport access vlan
vlan-id
2
30
413