Qos Map Dscp-Mutation - Cisco Small Business 300 1.1 Series Administration Manual

Quality of Service (QoS) Commands
78-20269-01 Command Line Interface Reference Guide
Syntax
qos dscp-mutation
no qos dscp-mutation
Command Mode
Global Configuration mode.
User Guidelines
Apply the DSCP-to-DSCP-mutation map to a port at the boundary of a Quality of
Service (QoS) administrative domain. If two QoS domains have different DSCP
definitions, use the DSCP-to-DSCP-mutation map to translate a set of DSCP
values to match the definition of another domain. Apply the map to ingress and to
DSCP-trusted ports only. Applying this map to a port causes IP packets to be
rewritten with newly mapped DSCP values at the ingress ports. If applying the
DSCP mutation map to an untrusted port, to class of service (CoS), or to an
IP-precedence trusted port.
Global trust mode must be DSCP or CoS-DSCP. In advanced CoS mode, ports
must be trusted.
Example
The following example applies the DSCP Mutation map to system DSCP trusted
ports.
Console(config)# qos dscp-mutation

41.36 qos map dscp-mutation

Use the qos map dscp-mutation Global Configuration mode command to
configure the DSCP to DSCP Mutation table. Use the no form of this command to
restore the default configuration.
Syntax
qos map dscp-mutation
no qos map dscp-mutation [
in-dscp out-dscp
to
in-dscp ]
41
593