Lldp Notifications - Cisco Small Business 300 1.1 Series Administration Manual

Link Layer Discovery Protocol (LLDP) Commands
78-20269-01 Command Line Interface Reference Guide
port or port- channel are members in a VLAN that has an IP address, that
address is not included because the address is associated with the VLAN.
Default Configuration
No IP address is advertised.
The default advertisement is automatic.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Each port can advertise one IP address.
Example
The following example sets the LLDP management address advertisement mode
to automatic on gi2.
Console(config)# interface gi2
Console(config-if)#

44.10 lldp notifications

Use the lldp notifications Interface Configuration (Ethernet) mode command to
enable/disable sending LLDP notifications on an interface. Use the no form of this
command to restore the default configuration.
Syntax
{enable | disable}
lldp notifications
no lldp notifications
Parameters
•
enable—Enables sending LLDP notifications.
•
disable—Disables sending LLDP notifications.
lldp management-address automatic
44
655