Cisco Small Business 300 1.1 Series Administration Manual page 307

EEE Commands
78-20269-01 Command Line Interface Reference Guide
Syntax
[interface-id]
show eee
Parameters
interface-id—Specify an interface ID. The interface ID must be an Ethernet port.
Defaults
N/A
Command Mode
EXEC
Examples
Example 1 - Brief Information about all ports
Switch>show eee
EEE globally enabled
EEE Administrate status is enabled on ports: gi1-6, gi7
EEE Operational status is enabled on ports: gi1, gi3-6, gi2, gi5
EEE LLDP Administrate status is enabled on ports: gi1-5
EEE LLDP Operational status is enabled on ports: gi1-5
Example 2 - Port in state notPresent, no information if port supports EEE
Switch> show eee gi10
Port Status: notPresent
EEE Administrate status: enabled
EEE LLDP Administrate status: enabled
EEE LLDP Administrate status: enabled
Example 3 - Port in status DOWN
Switch>show eee gi10
Port Status: DOWN
EEE capabilities:
24
308