Service-Acl - Cisco Small Business 300 1.1 Series Administration Manual

ACL Commands
78-20269-01 Command Line Interface Reference Guide
Example
console(config)# mac access-list extended server1
console(config-mac-al)# deny 00:00:00:00:00:01 00:00:00:00:00:ff any

40.10 service-acl

use the service-acl command in interface Configuration mode to bind an access
list(s) (ACL) to an interface.
Use the no form of this command to remove all ACLs from the interface.
Syntax
acl-name1 [acl-name2]
service-acl input
no service-acl input
Parameters
acl-name—Specifies an ACL to apply to the interface. See the user guidelines.
(Range: 0–32 characters). Use "" for empty string).
Default Configuration
No ACL is assigned.
Command Mode
Interface Configuration (Ethernet, Port-Channel) mode.
User Guidelines
The following rules govern when ACLs can be bound or unbound from an
interface:
•
IPv4 ACLs and IPv6 ACLs can be bound together to an interface.
•
A MAC ACL cannot be bound on an interface which already has an IPv4
ACL or IPv6 ACL bound to it.
•
Two ACLs of the same type cannot be bound to a port.
•
An ACL cannot be bound to a port that is already bound to an ACL, without
first removing the current ACL. Both ACLs must be mentioned at the same
time in this command.
40
548