Tacacs-Server Key - Cisco Small Business 300 1.1 Series Administration Manual

Terminal Access Controller Access-Control System Plus (TACACS+) Commands
78-20269-01 Command Line Interface Reference Guide
The default port-number is 49.
If timeout is not specified, the global value is used.
If key-string is not specified, the global value is used.
If source is not specified, the global value is used.
Command Mode
Global Configuration mode
User Guidelines
Multiple tacacs-server host commands can be used to specify multiple hosts.
If no host-specific timeout, key, or source values are specified, the global values
apply to each host.
Example
The following example specifies a TACACS+ host.
Console(config)# tacacs-server host
17.2

tacacs-server key

Use the tacacs-server key Global Configuration mode command to set the
authentication encryption key used for all TACACS+ communications between the
device and the TACACS+ daemon. Use the no form of this command to disable the
key.
Syntax
key-string
tacacs-server key
no tacacs-server key
Parameters
key-string—Specifies the authentication and encryption key for all TACACS+
communications between the device and the TACACS+ server. This key must
match the encryption used on the TACACS+ daemon. (Length: 0–128 characters)
172.16.1.1
17
215