Radius-Server Key - Cisco Small Business 300 1.1 Series Administration Manual

Remote Authentication Dial-In User Service (RADIUS) Commands
78-20269-01 Command Line Interface Reference Guide
If timeout is not specified, the global value is used.
If retransmit is not specified, the global value is used.
If key-string is not specified, the global value is used.
If the source value is not specified, the global value is used.
The default usage type is all.
Command Mode
Global Configuration mode
User Guidelines
To specify multiple hosts, multiple radius-server host commands can be used.
If no host-specific timeout, retries, deadtime or key-string values are specified, the
global values apply to each RADIUS server host.
The source parameter address type must be the same as that of the host
parameter.
Example
The following example specifies a RADIUS server host with IP address
192.168.10.1, authentication request port number 20, and a 20-second timeout
period.
Console(config)#
radius-server host
16.2

radius-server key

Use the radius-server key Global Configuration mode command to set the
authentication and encryption key for all RADIUS communications between the
device and the RADIUS daemon. Use the no form of this command to restore the
default configuration.
Syntax
key-string
radius-server key [
no radius-server key
192.168.10.1
]
20
auth-port timeout
16
20
207