Show Lldp Local Tlvs-Overloading - Cisco Small Business 300 1.1 Series Administration Manual

Link Layer Discovery Protocol (LLDP) Commands
78-20269-01 Command Line Interface Reference Guide
Network policies:
Location:
Civic-address: 61:62:63:64:65:66

44.23 show lldp local tlvs-overloading

When an LLDP packet contains too much information for one packet, this is called
overloading. Use the show lldp local tlvs-overloading EXEC mode command to
display the status of TLVs overloading of the LLDP on all ports or on a specific
port.
Syntax
show lldp local tlvs-overloading
Parameters
interface-id—Specifies a port ID.
Default Configuration
If no port ID is entered, the command displays information for all ports.
Command Mode
EXEC mode
User Guidelines
The command calculates the overloading status of the current LLDP configuration,
and not for the last LLDP packet that was sent.
Example
Switch# show lldp local tlvs-overloading gi1
TLVs Group
------------
Mandatory
LLDP-MED Capabilities
LLDP-MED Location
802.1
[interface-id]
Bytes Status
------ --------------
31 Transmitted
9 Transmitted
200 Transmitted
1360 Overloading
44
670