Trust - Cisco Small Business 300 1.1 Series Administration Manual

Quality of Service (QoS) Commands
78-20269-01 Command Line Interface Reference Guide
Example
The following example displays all policy maps.
Console> show policy-map
Policy Map policy1
class class1
set IP dscp 7
Policy Map policy2
class class 2
police 96000 4800 exceed-action drop
class class3
police 124000 96000 exceed-action policed-dscp-transmit

41.10 trust

Use the trust Policy-map Class Configuration mode command to configure the
trust state. This command is relevant only when QoS is in advanced,
ports-not-trusted mode. Trust indicates that traffic is sent to the queue according
to the packet's QoS parameters (UP or DSCP).
Use the no form of this command to return to the default trust state.
This command is only available when QoS is in advanced mode.
Syntax
trust
no trust
Parameters
N/A
Default Configuration
The default state is according to the mode selected in the
(advanced mode). The type of trust is determined in
qos command
qos advanced-mode
41
trust.
566