Macro Auto Persistent - Cisco Small Business 300 1.1 Series Administration Manual

Smartport Commands
78-20269-01 Command Line Interface Reference Guide
Default Configuration
N/A
Command Mode
Interface Configuration mode (Ethernet Interface, Port Channel)
User Guidelines
When a Smartport macro fails at an interface, the Smartport type of the interface
becomes Unknown. You must diagnose the reason for the failure on the interface
and/or Smartport macro, and correct the error. Before you or Auto Smartport are
allowed to reapply the desired Smartport macro, you must reset the interface
using the macro auto resume command, which changes the Smartport type of the
interface to Default. Then you can run
Example
Changes the Smartport type from unknown to default and resumes the Smartport
feature on port 1.
console(conf)interface gi1
console(conf-if)#macro auto resume
43.5

macro auto persistent

The macro auto persistent Interface Configuration mode command sets the
interface as a Smartport persistent interface. The no format of the command
returns it to default.
Syntax
macro auto persistent
no macro auto persistent
Parameters
N/A
Default Configuration
Not persistent.
macro auto trunk refresh.
43
633