Cisco Small Business 300 1.1 Series Administration Manual page 603

Quality of Service (QoS) Commands
78-20269-01 Command Line Interface Reference Guide
Parameters
•
reserved add/remove—Add or remove the table of reserved addresses
below.
•
ip-address—Adds/discards packets with the specified IP source or
destination address.
•
mask—Specifies the network mask of the IP address.
•
prefix-length—Specifies the number of bits that comprise the IP address
prefix. The prefix length must be preceded by a forward slash (/).
•
reserved—Discards packets with the source or destination IP address in
the block of the reserved (Martian) IP addresses. See the User Guidelines
for a list of reserved addresses.
Default Configuration
Martian addresses are allowed.
Command Mode
Global Configuration mode
User Guidelines
For this command to work,
security-suite deny martian-addresses
in the following table:
Address block
0.0.0.0/8 (except
when 0.0.0.0/32 is
the source
address)
127.0.0.0/8
192.0.2.0/24
security-suite enable
reserved
Present use
Addresses in this block refer to source hosts
on "this" network.
This block is assigned for use as the Internet
host loopback address.
This block is assigned as "TEST-NET" for use
in documentation and example code.
must be enabled globally.
adds or removes the addresses
41
605