Dot1X Timeout Supp-Timeout - Cisco Small Business 300 1.1 Series Administration Manual

802. 1 x Commands
78-20269-01 Command Line Interface Reference Guide
User Guidelines
The default value of this command should be changed only to adjust to unusual
circumstances, such as unreliable links or specific behavioral problems with
certain clients and authentication servers.
Example
The following example sets the maximum number of times that the device sends
an EAP request/identity frame to 6
Console(config)# interface gi15
Console(config-if)#
20.9

dot1x timeout supp-timeout

Use the dot1x timeout supp-timeout Interface Configuration (Ethernet) mode
command to set the time interval during which the device waits for a response to
an Extensible Authentication Protocol (EAP) request frame from the client before
resending the request. Use the no form of this command to restore the default
configuration.
Syntax
dot1x timeout supp-timeout
no dot1x timeout supp-timeout
Parameters
supp-timeout seconds
device waits for a response to an EAP request frame from the client before
resending the request. (Range: 1–65535 seconds)
Default Configuration
The default timeout period is 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
dot1x max-req 6
seconds
—Specifies the time interval in seconds during which the
20
256