Traffic-Shape; Traffic-Shape Queue - Cisco Small Business 300 1.1 Series Administration Manual

Quality of Service (QoS) Commands
78-20269-01 Command Line Interface Reference Guide

41.20 traffic-shape

The egress port shaper controls the traffic transmit rate (Tx rate) on a port.
Use the traffic-shape Interface Configuration mode command to configure the
egress port shaper. Use the no form of this command to disable the shaper.
Syntax
traffic-shape committed-rate
no traffic-shape
Parameters
•
committed-rate—Specifies the maximum average traffic rate (CIR) in kbits
per second (kbps). (Range: GE: 64kbps–maximum port speed; 10GE:
64Kbps–maximum port speed)
•
committed-burst—Specifies the maximum permitted excess burst size
(CBS) in bytes. (Range: 4096 - 16762902 bytes)
Default Configuration
The shaper is disabled.
Command Mode
Interface Configuration (Ethernet, Port-channel) mode
Example
The following example sets a traffic shaper on gi5 on queue 1 when the average
traffic rate exceeds 124000 kbps or the normal burst size exceeds 9600 bytes.
Console(config)#
interface
Console(config-if)#

41.21 traffic-shape queue

The egress port shaper controls the traffic transmit rate (Tx rate) on a queue on a
port.
Use the traffic-shape queue Interface Configuration mode command to configure
the egress queue shaper. Use the no form of this command to disable the shaper.
[ committed-burst
gi
5
traffic-shape 1 124000 9600
]
41
578