Address Table Commands
78-20269-01 Command Line Interface Reference Guide
•
port-channel-list
port-channel
nonconsecutive port-channels with a comma and no spaces. Use a hyphen
to designate a range of port channels.
Default Configuration
No forbidden addresses are defined.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
Before defining forbidden ports, the multicast group should be registered.
You can execute the command before the VLAN is created.
Example
The following example registers an IPv6 multicast address, and forbids the IPv6
address on port
9 within VLAN 8.
gi
console(config)#
interface vlan
Console(config-if)#
Console(config-if)#
FF00:0:0:0:4:4:4
add
27.12 bridge multicast ipv6 source group
Use the bridge multicast ipv6 source group Interface Configuration (VLAN) mode
command to register a source IPv6 address - multicast IPv6 address pair to the
bridge table, and statically add or remove ports to or from the source-group. Use
the no form of this command to unregister the source-group-pair.
Syntax
bridge multicast ipv6 source
[[add | remove] {ethernet interface-list | port-channel port-channel-list}]
no bridge multicast ipv6 source
—Specifies a list of port channels. Separate
8
bridge multicast ipv6 ip-address
bridge multicast ipv6 forbidden ip-address
gi9
ipv6-source-address
ipv6-address
FF00:0:0:0:4:4:4
ipv6-multicast-address
group
ipv6-multicast-address
group
27
337